Thumb throttle variabel speed control

This 0-5 Volt Hall sensor thumb throttle can be used for variable speed control. The spring-loaded thumb throttle will immediately return to the 0 position when released. The gray button can be used to determine the direction of travel (6-wire connection) or for on/off (5-wire connection). 3 LED lights can indicate the status of a 24V AGM battery or a 29,7V Lithium battery. The thumb throttle comes with a cable of almost 2 meters long.

Hall sensor

The thumb throttle with Hall sensor sends out a signal between 0.8V and 4.2V. The control voltage is 5V from this throttle.

Specifications

Material: ABS, PA66, GF20
Weight: about 150Gr
Mounting: For 22.5mm tube
Colour: black/grey

Thumb throttle connection manual

NB! We assume that the installer has knowledge of electronics and is able to make plug connections between different electronic components. Bad plug connections can cause irreparable damage to the various components. Bad plug connections can cause a short circuit that could cause a fire. DaviLot is in no way responsible or liable for damage caused by incorrect installation of the parts. Damage to products resulting from incorrect installation is excluded from the warranty.

10401040 Thumb throttle with button for FWD/REV:

Red: +5V
Black: - negative
White: Hall signal 0.8V – 4.2V
Yellow and Brown: forward/backward
Green: Battery positive 29,7V signal

10401041 Thumb throttle with button for ON/OFF

Red: +5V
Black: - negative
White: Hall signal 0.8V – 4.2V
Yellow and black: ON/OFF
Green: Battery positive 29,7V signal

10401042 Thumb throttle with button for FWD/REV:

Red: +5V
Black: - negative
White: Hall signal 0.8V – 4.2V
Yellow and Brown: forward/backward
Green: Battery positive 25,4V signal