Quinder Brushless BLDC Controller 48V
This 48V Controller for brushless motors has been specially developed for the Quinder Brushless 48V 8" HUB motor. The Controller can be connected plug-and-play to this motor. The controller is part of a set that also includes the throttle and the FWD/REV plug -and-play can be connected to this controller.
Cables
1. 48Volt power cable consisting of 48V + and 48V -. Note that these cables must never be reversed as this will irreparably damage the Hall sensors
2. Output cable to Brushless Motor consisting of: Motor Phase A, Motor Phase B and motor Phase C, Motor Hall Sensor +, Motor Hasll sensor -, Motor Hall Sensor Signal A, Motor Hall Sensor Signal B, Speed ​​signal, Temperature signal
3. Throttle cable consisting of: RX protocol, TX protocol, 48V+, Key, 48V-, Throttle Hall -, Throttle signal, Throttle +
4. Loudspeaker consisting of loudspeaker + and loudspeaker -
5. Program cable
Quinder controller specifications
Current limit: 20A +/- 1A
Current nominal: 10A
Undervoltage: 42V +/-1V
Temp Warning: Temp over 110 degrees - every other second a one second peep Motor shut off
Low voltage warning: 0.2seconds peep 1 second silent
Speed ​​measurement by HALL sensor
Dimensions: 110mm x 70mm x 38mm
Download here the specification sheet